;distortion module ;begin distorting signal at -18dB (input referred). ;At the output, the signal will begin to distort at half ;of full scale, and further increase of input signal will ;cause increasingly 'flattened' signal peaks. ;This is an ideal module to be driven by a compressor, ;where sustained notes can be on the edge of distortion, ;and actual signal clipping can be prohibited. ;mono in, mono out, no controls, 24 ticks equ mono reg0 equ abs reg1 equ sign reg2 sof 0,-1 ;load ACC with -1 wrax sign,0 ;set sign to negative rdax adcl,0.5 rdax adcr,0.5 wrax mono,1 ;sum inputs to mono skp neg,sgnset ;skip if mono input is negative sof 0,0.999 ;set sign to +1 if input is pos (close enough) wrax sign,0 ;set sign to pos if signal is pos. sgnset: ;jump here if negative input, sign is now set ldax mono ;get input signal again absa ;positive only wrax abs,1 ;store absolute signal in abs, keep in ACC sof 1,-0.125 ;subtract 1/8 skp neg,nodist ;if signal is below this limit, ;then no distortion is required ;distort signal because it is above 1/8th of full scale. ;do this by obtaining the 1/X of the signal, and subtracting ;this value (scaled) from 1/4. The result is the distorted ;portion of the overall DC transfer function ;at the transition between clean and distorted audio (+/-0.125), ;the LOG of the abs signal, after inverting (-1) to cause the 1/X ;function, must be scaled (-0.375) so that after the EXP function, ;the value is also equal to 0.125. Otherwise, the clean and the ;distorted waveforms will not meet properly. ldax abs log -1,-0.375 ;1/x, displace result exp 1,0 sof -1,0.25 ;subtract 1/x from 0.25 skp run,distout ;skip always nodist: sof 1,0.125 ;add threshold value back distout: mulx sign ;put sign back sof -2,0 sof -2,0 ;bring up gain (12dB) wrax dacl,1 wrax dacr,0 ;write outputs ;KB 07/03/06 综合久久—本道中文字幕,欧美AV专区一中文字-日本伦中文字幕免费eeuss-欧美日韩精品一区二在线,国内自拍视频二区,国产高清在线观看91最新